Datasheet

DES/3DES/AES VPN Encryption Module (AIM-VPN/SSL-1, AIM-VPN/SSL-2, and AIM-VPN/SSL-3)
show crypto engine
9
Cisco IOS Security Configuration Guide
show crypto engine
To display a summary of the configuration information for the crypto engines, use the
show crypto engine command in privileged EXEC mode.
show crypto engine [accelerator | brief | configuration | connections | qos]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines This command displays all crypto engines and displays the AIM-VPN product name.
Examples The following example of the show crypto engine command and the brief keyword shows typical crypto
engine summary information:
Router# show crypto engine brief
crypto engine name: Virtual Private Network (VPN) Module
crypto engine type: hardware
State: Enabled
Location: aim 0
accelerator (Optional) Displays crypto accelerator information.
brief (Optional) Displays a summary of the configuration information for the
crypto engine.
configuration (Optional) Displays the version and configuration information for the
crypto engine.
connections (Optional) Displays information about the crypto engine connections.
qos (Optional) Displays quality of service (QoS) information.
This keyword has a null output if any advanced integration module
(AIM) except AIM-VPN/SSL-1 is used. The command-line interface
(CLI) will accept the command, but there will be no output.
Release Modification
11.2 This command was introduced on the Cisco 7200, RSP7000, and 7500
series routers.
12.2(15)ZJ This command was implemented for the AIM-VPN/BPII on the following
platforms: Cisco 2610XM, Cisco 2611XM, Cisco 2620XM,
Cisco 2621XM, Cisco 2650XM, and Cisco 2651XM.
12.3(4)T This command was integrated into Cisco IOS Release 12.3(4)T.
12.4(4)T IPv6 address information was added to command output.
12.4(9)T AIM-VPN/SSL-3 encryption module information was added to command
output.
12.2(33)SRA This command was integrated into Cisco IOS release 12.(33)SRA.