Datasheet

DES/3DES/AES VPN Encryption Module (AIM-VPN/SSL-1, AIM-VPN/SSL-2, and AIM-VPN/SSL-3)
show crypto engine accelerator statistic
12
Cisco IOS Security Configuration Guide
show crypto engine accelerator statistic
To display IP Security (IPsec) encryption statistics and error counters for the onboard hardware
accelerator of the router or the IPsec Virtual Private Network (VPN) Shared Port Adapter (SPA), use the
show crypto engine accelerator statistic command in privileged EXEC mode.
show crypto engine accelerator statistic
IPsec VPN SPA
show crypto engine accelerator statistic [slot slot/subslot | all] [detail]
Syntax Description
Command Modes Privileged EXEC
Command History
slot slot/subslot (IPsec VPN SPA only—Optional) Chassis slot number and secondary slot
number on the SPA Interface Processor (SIP) where the SPA is installed.
Refer to the appropriate hardware manual for slot information. For SIPs,
refer to the platform-specific SPA hardware installation guide or the
corresponding “Identifying Slots and Subslots for SIPs and SPAs” topic in
the platform-specific SPA software configuration guide.
Displays platform statistics for the corresponding IPsec VPN SPA. This
output will not include network interface controller statistics.
all (IPsec VPN SPA only—Optional) Displays platform statistics for all IPsec
VPN SPAs on the router. This output will not include network interface
controller statistics.
detail (IPsec VPN SPA only—Optional) Displays platform statistics for the IPsec
VPN SPA and network interface controller statistics. Note that the
controller statistics contain Layer 2 (L2) counters.
Release Modification
12.1(1)XC This command was introduced for the Cisco 1700 series router and other
Cisco routers that support hardware accelerators for IPsec encryption.
12.1(3)XL This command was implemented on the Cisco uBR905 cable access router.
12.2(2)XA Support was added for the Cisco uBR925 cable access router.
12.2(13)T This command was integrated into Cisco IOS Release 12.2(13)T and
implemented for the AIM-VPN/EPII and AIM-VPN/HPII on the following
platforms: Cisco 2691, Cisco 3660, Cisco 3725, and Cisco 3745. In
addition, the output for this show command was enhanced to display
compression statistics.
12.2(15)ZJ This command was implemented for the AIM-VPN/BPII on the following
platforms: Cisco 2610XM, Cisco 2611XM, Cisco 2620XM,
Cisco 2621XM, Cisco 2650XM, and Cisco 2651XM.
12.3(4)T The AIM-VPN/BPII was integrated into Cisco IOS Release 12.3(4)T on the
following platforms: Cisco 2610XM, Cisco 2611XM, Cisco 2620XM,
Cisco 2621XM, Cisco 2650XM, and Cisco 2651XM.