User guide

26
Chapter 6: Configuring the ADSL2+ Gateway
The Setup - Voice Tab
ADSL2+ Gateway with VoIP
RTP Bytes Sent. Displayed here is the number of RTP bytes sent by the Gateway.
RTP Packets Recv. Displayed here is the number of RTP packets received by the Gateway.
RTP Bytes Recv. Displayed here is the number of RTP bytes received by the Gateway.
SIP Messages Sent. Displayed here is the number of SIP messages sent by the Gateway.
SIP Bytes Sent. Displayed here is the number of SIP bytes sent by the Gateway.
SIP Messages Recv. Displayed here is the number of SIP messages received by the Gateway.
SIP Bytes Recv. Displayed here is the number of SIP bytes received by the Gateway.
External IP. Displayed here is the external IP address used for NAT mapping.
Line 1 Status
Hook State. Displayed here is the status of the Internet phone line’s readiness. On indicates that it is ready for use, while Off
indicates that it is in use.
Registration State. Shown here is the status of the line’s registration with the ITSP.
Last Registration At. Shown here are the last date and time the line was registered.
Next Registration In. Shown here is the number of seconds until the next registration.
Message Waiting. This indicates whether you have new voicemail waiting.
Call Back Active. This indicates whether a call back request is in progress.
Last Called Number. Displayed here is the last number called.
Last Caller Number. Displayed here is the number of the last caller.
Mapped SIP Port. Shown here is the port number of the NAT mapped SIP port.
Calls 1 and 2 have the same status information available.
Call 1/2 State. Displayed here is the status of the call.
Call 1/2 Tone. Displayed here is the type of tone used by the call.
Call 1/2 Encoder. Displayed here is the codec used for encoding.
Call 1/2 Decoder. Displayed here is the codec used for decoding.