User guide

12
Chapter 5: Using the Interactive Voice Response Menu
Using the Interactive Voice Response Menu
ADSL2+ Gateway with VoIP
Set the Mode 201 Press 0 to select the router/
NAT mode.
Press 1 to select the bridge/
switch mode.
If the Voice Gateway acts as
the router for your network,
use the router/NAT mode.
If your network already has a
router, use the bridge/switch
mode.
Enable/Disable WAN Access to
the Web-based Utility
7932 Press 1 to enable.
Press 0 to disable.
Use this setting to enable or
disable WAN access to the
web-based utility. (This Utility
lets you configure the Voice
Gateway.)
Manual Reboot 732668 After you hear, “Option
successful,” hang up the
phone. The Voice Gateway will
automatically reboot.
Factory Reset 73738 Press 1 to confirm.
Press * (star) to cancel.
If necessary, enter the
password. The Voice Gateway
will request confirmation; enter
1 to confirm. You will hear,
“Option successful.” Hang up
the phone. The Voice Gateway
will reboot, and all settings will
be reset to their factory default
settings.
User Factory Reset 877778 Press 1 to confirm.
Press * (star) to cancel.
The Voice Gateway will request
confirmation; enter 1 to
confirm. You will hear, “Option
successful.” Hang up the
phone. The Voice Gateway will
reboot and all user-
configurable settings will be
reset to their factory default
settings.
Table 1: Interactive Voice Response Menu
Action Command (press these
keys on the telephone)
Choices Description
NOTE: This feature may be protected by a
password available only from your ITSP.
If you need to enter a password, refer to the
following section, “Entering a Password.”