Specifications

2-41
Catalyst 4500 Se ries S wit ch C is co IO S C om mand R efer ence —Re lease I OS XE 3 .3.0 XO(1 5.1 (1)XO)
OL_28738-01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
auto qos classify
class AutoQos-4.0-Default-Classify
set dscp default
set cos 0
C. Template for egress q ueue classe s along with the SRND4 output policy that uses t he egress classes t o
allocate 8 queues. This template is required by all SRND4 commands:
class-map match-all AutoQos-4.0-Priority-Queue
match qos-group 32
class-map match-all AutoQos-4.0-Control-Mgmt-Queue
match qos-group 16
class-map match-all AutoQos-4.0-Multimedia-Conf-Queue
match qos-group 34
class-map match-all AutoQos-4.0-Multimedia-Stream-Queue
match qos-group 26
class-map match-all AutoQos-4.0-Trans-Data-Queue
match qos-group 18
class-map match-all AutoQos-4.0-Bulk-Data-Queue
match qos-group 10
class-map match-any AutoQos-4.0-Scavenger-Queue
match qos-group 8
match dscp cs1
Because police commands executed in policy map configuration mode do not allow the remarking of
qos-groups for traffic flows that exceed defined rate limits, you must configure
AutoQos-4.0-Scavenger-Queue to match either qos-group 7 or dscp af11. When you enter the auto qos
classify police command, traffic flows that violate the defined rate limit are remarked to cs1 but retain
their original qos-group clas sification because qos- groups cannot be remark ed as an exceed action.
However, because AutoQos-4. 0-Scavenger-Que ue is d efined before all other qu eues in the output policy
map, remarked packets fall into it, des pite retaining their original qos-group lab els.
policy-map AutoQos-4.0-Output-Policye
bandwidth remaining percent 1
class AutoQos-4.0-Priority-Queue
priority
police cir percent 30 bc 33 ms
conform-action transmit exceed-action drop
class AutoQos-4.0-Control-Mgmt-Queue
bandwidth remaining percent 10
class AutoQos-4.0-Multimedia-Conf-Queue
bandwidth remaining percent 10
class AutoQos-4.0-Multimedia-Stream-Queue
bandwidth remaining percent 10
class AutoQos-4.0-Trans-Data-Queue
bandwidth remaining percent 10
dbl
class AutoQos-4.0-Bulk-Data-Queue
bandwidth remaining percent 4
dbl
class class-default
bandwidth remaining percent 25
dbl
Interfac e Lev el Comm ands G enera ted
For Fa/Gi g Por ts:
Switch(config-if)# service-policy input AutoQos-4.0-Classify-Input-Policy
service-policy output AutoQos-4.0-Output-Policy