Specifications

2-769
Catalyst 4500 Se ries S wit ch C is co IO S C om mand R efer ence —Re lease I OS XE 3 .3.0 XO(1 5.1 (1)XO)
OL_28738 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show storm-control
Switch#
This is an example of output from the show storm-control command for a specified interface:
Switch# show storm-control fastethernet2/17
Interface Filter State Level Current
--------- ------------- ------- -------
Fa2/17 Forwarding 50.00% 0.00%
Switch#
This is an example of output from the show storm-control command for a specified interface:
Switch# show storm-control interface fastethernet6/1
Interface Filter State Broadcast Multicast Level
--------- ------------- ------- ------- -----
Fa6/1 Blocking Enabled Disabled 81%
Switch#
Table 2-31 describes the fields in the show storm-control displa y.
Related Commands
Table 2-31 show storm-cont rol Fiel d Descript ions
Field Description
Interface Displays the ID of the interface.
Filter State Displays the status of the filter:
• Blocking—Storm contr ol is enabled, and a storm ha s occurred.
• Forwarding—Storm contr ol is enabled, and no sto rms have occurred.
• Inactive—Storm control is disabled.
Level Displays the threshold level set on the interface for broadcast traffic.
Current Displays the bandwidth utilization of broadcast traffic as a percentage of
total available bandwidth. This field is valid only when storm control is
enabled.
Note N/A is displa yed for interfaces that do storm control in the hardware.
Command Description
storm-control Enables broadcast storm control on a port and specifies
what to do when a storm occurs on a port.
show interfaces counters Displays the traffic on the physical interface.
show running-config Displays the running configuration of a switch.