Specifications

2-744
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0XO(15.1(1)XO)
OL_28738 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show qos interface
show qos inter face
To display queueing information, use the show qos interface command.
show qos inter face {f ast eth ern et in terface-number | gigabitethernet inte rface-numbe r} |
[vlan vlan_id | port-channel number]
Syntax Description
Defaults T his command has no default settings.
Command Modes Privileged EXE C mode
Examples This exampl e shows how to display queuei ng information:
Switch# show qos interface fastethernet 6/1
QoS is enabled globally
Port QoS is enabled
Administrative Port Trust State: ‘dscp’
Operational Port Trust State: ‘untrusted’
Port Trust Device:'cisco-phone'
Default DSCP:0 Default CoS:0
Tx-Queue Bandwidth ShapeRate Priority QueueSize
(bps) (bps) (packets)
1 31250000 disabled N/A 240
2 31250000 disabled N/A 240
3 31250000 disabled normal 240
4 31250000 disabled N/A 240
Switch#
Related Commands
fastethernet interface-number Specifies the Fast Ethernet 802.3 interface.
gigabitethernet interface-number Specifies the Gigabit Ethernet 8 02.3z interface.
vlan vlan_id (Optional) Specifies the VLAN ID; valid values are from 1 to
4094.
port-c ha nne l number (Optional) Specifies the port channel; valid ranges are from
1 to 64.
Command Description
show qos Displays QoS information.
tx-queue Configures the transmit queue parameters for an interface.