Specifications

2-419
Catalyst 4500 Se ries S wit ch C is co IO S C om mand R efer ence —Re lease I OS XE 3 .3.0 XO(1 5.1 (1)XO)
OL_28738 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
police (two rates)
Figure 2-1 Marking Packets and Assigning Actions with the Two-Rate Policer
Examples This example shows how to configure two-rate traffic policing on a class to limit traffic to an average
committed rate of 500 kbps and a peak rate of 1 Mbps:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# class-map police
Switch(config-cmap)# match access-group 101
Switch(config-cmap)# policy-map policy1
Switch(config-pmap)# class police
Switch(config-pmap-c)# police cir 500000 bc 10000 pir 1000000 be 10000 conform-action
transmit exceed-action set-prec-transmit 2 violate-action drop
Switch(config-pmap-c)# interface gigabitethernet 6/1
Switch(config-if)# service-policy output policy1
Switch(config-if)# end
Switch# show policy-map policy1
Policy Map policy1
Class police
police cir 500000 conform-burst 10000 pir 1000000 peak-burst 10000 conform-action
transmit exceed-action set-prec-transmit 2 violate-action drop
Switch#
Traffic marked as conforming to the average committed rate (500 kbps) will be sent as is. Traffic marked
as exceeding 500 kbps, but not exceeding 1 Mbps, will be marked with IP Precedence 2 and then sent.
All traffic marked as exceeding 1 Mbps will be dropped. The burst parameters are set to 10000 bytes.
In the following example, 1.25 Mbps of traff ic is sent (“offered”) to a policer class:
Switch# show policy-map interface gigabitethernet 6/1
GigabitEthernet6/1
No
PIR
Be
Yes
Action
B > Tp
Packet of size B
Violate
No
Yes
Action
B > Tc
Exceed
Action
Conform
CIR
Bc
60515