Specifications

2-415
Catalyst 4500 Se ries S wit ch C is co IO S C om mand R efer ence —Re lease I OS XE 3 .3.0 XO(1 5.1 (1)XO)
OL_28738 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
police rate
police rate
To configure single or dual ra te policer, use the police rate command in policy-map configuration mode.
To remove traffic policing from the configuration , use the no form of this command.
Syntax for Bytes Per Second
police rate units bps [burst burst-in-bytes bytes] [pe ak-rate peak-rate -in-bps bps] [pa ck -bu rs t
peak-burst-in-bytes by te s]
no police rate units bps [burst burst-in-bytes bytes] [peak-rate peak-rate-in-bps bps]
[pack-burst peak-burst-in-bytes bytes]
Syntax for Percent
police rate percent percentage [burst ms ms] [peak-rate percent perce n tag e] [pack-burst ms ms]
no police rate percent percentage [burst ms ms] [peak-rate percent percen ta ge] [pack-burst ms
ms]
Syntax Description
Command Default This command is disabled by default .
units Specifies the traffic police rate in bits per second. Valid range is 32,000 to
32,000,000,000.
bps (Optional) Bits per second (bps) will be used to determine the rate at which
traffic is policed.
Note If a rate is not specified, traffic is policed via bps.
burst burst- in-bytes
bytes
(Optional) Specifies the burst rate, in bytes, will be used for policing traffic.
Valid range is from 64 to 2,596,929,536.
peak-rate
peak-rate-in-bps bps
(Optional) Specifies the peak burst value, in bytes, for the peak rate. Valid
range is from 32,000 to 32,000,000 ,000.
peak-burst
peak-burst-in-bytes
bytes
(Optional) Specifies the peak burst value, in bytes, will be used for policing
traffic. If the police rate is specified in bps, the valid range of values is 64 to
2,596,929,536.
percent (Optional) A percentage of interface bandwidth will be used to determine the
rate at which traffic is policed.
percentage (Optional) Bandwidth percentage. Valid range is a number from 1 to 100.
burst ms ms (Optional) Burst rate, in milliseconds, will be used for policing tra ffic. Valid
range is a number from 1 to 2,000.
peak-rate percent
percentage
(Optional) A percentage of interface bandwidth will be used to determine the
PIR. Valid range is a number from 1 to 100.
peak-burst ms ms (Optional) Peak burst rate, in milliseconds, will be used for policing traffic.
Valid range is a number from 1 to 2,000.