Specifications

2-318
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0XO(15.1(1)XO)
OL_28738 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
lacp system-priority
lacp system-priority
To set the priority of the system for LACP, use the lacp system-priority command.
lacp system-priority priority
Syntax Description
Defaults P riority is set to 32768.
Command Modes Global c onfiguratio n mode
Usage Guidelines You must assign each switch that is running LACP a system priority that can be specified automatically
or by entering the lacp system-priority command. The system priority is used with the switch MAC
address to form the system ID and is also used during negotiation with other systems.
Although this command is a glob al configuration comm and, the priority value is su pported on port
channels with LACP-enable d physical interfaces.
When setting the priority, tthe higher numbers indicate lower priorities.
You can also enter the lacp system-priority command in interface configuration mode. After you enter
the command, the system defaults to global configuration mode.
Examples This example shows how to set the system priority:
Switch(config)# lacp system-priority 23748
Switch(config)#
Related Commands
priority Priority of the system; valid values are from 1 to 65535.
Command Description
channel-group Assigns and configure an EtherChannel interface to an
EtherChannel grou p.
channel-protocol Enables LACP or PAgP on an interface.
lacp system-priority Se ts the priority of the system for LACP.
show lacp Displays LACP information.