Specifications

2-127
Catalyst 4500 Se ries S wit ch C is co IO S C om mand R efer ence —Re lease I OS XE 3 .3.0 XO(1 5.1 (1)XO)
OL_28738-01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug condition standby
debug condition standby
To limit the debugging output for the standby st ate changes, use the debug con dition stan dby comm and.
To disable the debugging output, use the no form o f this command.
debug condition standby {fastethernet mod/port | GigabitEthernet mod/port |
port-channel interface-num | vlan vlan_id group-number}
no debug condition standby {fastethern et mod/po rt | GigabitEthernet mod/port |
port-channel interface-num | vlan vlan_id group-number}
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Usage Guidelines If you attempt to remove the only condition set, you will be prompted with a message asking if you want
to abort the removal operation. You can enter n to abort the removal or y to proceed with the removal. If
you remove the only condition set, an excessive number of debugging mes sages might occur.
Examples This example shows how to limit the debugging outp ut to group 0 in VLAN 1 :
Switch# debug condition standby vlan 1 0
Condition 3 set
Switch#
fastethernet Limits the debugging to Fast Etherne t interfaces.
mod/port Number of the module and port.
GigabitEthernet Limits the debugging to Gigabit Ethernet interfaces.
port-channel interface_num Limits the debugging output to port-channel i nterfaces; valid values
are from 1 to 64.
vlan vlan_id Limits the debugging of a condition on a VLAN interface; valid values
are from 1 to 4094.
group-number VLAN group numbe r; valid values are from 0 to 255.