Specifications

2-70
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0XO(15.1(1)XO)
OL_28738-01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
call-home (global configuration)
call-home (global conf iguration)
To enter call home configuration submode , use the call-home command in global configuration mode.
call-home
Syntax Description This command has no arguments or keywo rds.
Command Default This command has no default settings.
Command Modes Global c onfiguratio n mode
Usage Guidelines O nce you enter the call-home command, the p rompt c hanges to Switch (cfg-cal l-home)#, a nd you have
access to the call home configuration commands as follows:
• al ert-group—Enables or disab les an alert group. See the alert-group command.
• contact-email-addr email-address—Assigns the system contac t’s e-mail address. You can enter up
to 128 alphanumeric characters in e-mail address format with no spaces.
• contract-id alphanumeric—Specifies the customer contract identification for Cisco
AutoNotification. You can enter up to 64 alpha numeric c haracter s. If you inclu de spaces, you m ust
enclose your entry in quotes (“ ”).
• copy profile source-profile target-profile—Creates a new destination profile (target-profile) with
the same configuration settings as the existing profile (source-profile).
• customer-id name—Provides customer identification for Cisco AutoNotify. You can enter up to 256
alphanumeric characte rs. If you include space s, you must enclose your entry in quotes (“ ”).
• default—Sets a command to its defaults.
• exit—Exits call home configu ration mode and returns to globa l configuration m ode.
• mail-server {ipv4-address | name} priority priority—Assigns the customer’s e-mail server address
and relative priority. You can enter an IP address or a fully qualified domain name (FQDN), and
assign a priority from 1 (highest) to 100 (lowest).
You can define backup e- mail servers by repeatin g the mail-server command and entering different
priority numbers.
• no—Negates a command or set its defaults.
• phone-number +phone-number—Specifies the phone number of the contact person. The
phone-number value must begin with a plu s (+) prefix, and may contai n only dashes (-) and
numbers. You can enter up to 16 characters. If you include spaces, you must enclose your entry in
quotes (“ ”).
• profile name—Enters call-home pr ofile conf iguration mode. See th e profile command.
• rate-limit threshold—Co nfigures the call-home message rate-limit threshold; valid values are from
1 to 60 messages per minute.
• sender {from | repl y-to } email- address—Specifies the call-home message sender’s e-mail
addresses. You can enter up t o 128 alphanumeri c character s in e-mail a ddress fo rmat with no spaces.