Specifications

2-49
Catalyst 4500 Se ries S wit ch C is co IO S C om mand R efer ence —Re lease I OS XE 3 .3.0 XO(1 5.1 (1)XO)
OL_28738-01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
auto qos srnd4
match qos-group 34
class-map match-all AutoQos-4.0-Multimedia-Stream-Queue
match qos-group 26
class-map match-all AutoQos-4.0-Trans-Data-Queue
match qos-group 18
class-map match-all AutoQos-4.0-Bulk-Data-Queue
match qos-group 10
class-map match-any AutoQos-4.0-Scavenger-Queue
match qos-group 8
match dscp cs1
Because the police commands executed in policy map configuration mode do not allow the re-marking
of qos-groups for traffic flows that exceed defined rate limits, you should con figure
AutoQos-4.0-Scavenger-Queue to match either qos-group 7 or dscp af11. When you enter the auto qos
classify police command, traffic flows that violate the defined rate limit are remarked to cs1 but retain
their original qos-group clas sificatio because suc h groups cannot be re-mar ked as an exceed action.
However, because AutoQos-4. 0-Scavenger-Que ue is d efined before all other qu eues in the output policy
map, re-marked packets fall into it, despite retaining their original qos-group labels.
policy-map AutoQos-4.0-Output-Policy
class AutoQos-4.0-Scavenger-Queue
bandwidth remaining percent 1
class AutoQos-4.0-Priority-Queue
priority
police cir percent 30 bc 33 ms
conform-action transmit exceed-action drop
class AutoQos-4.0-Control-Mgmt-Queue
bandwidth remaining percent 10
class AutoQos-4.0-Multimedia-Conf-Queue
bandwidth remaining percent 10
class AutoQos-4.0-Multimedia-Stream-Queue
bandwidth remaining percent 10
class AutoQos-4.0-Trans-Data-Queue
bandwidth remaining percent 10
dbl
class AutoQos-4.0-Bulk-Data-Queue
bandwidth remaining percent 4
dbl
class class-default
bandwidth remaining percent 25
dbl
—Interface Level Commands Generated
For Fa/Gi g Por ts:
If Layer 2 interface:
Switch(config-if)# no service-policy input AutoQos-VoIP-Input-Cos-Policy
no service-policy output AutoQos-VoIP-Output-Policy
service-policy input AutoQos-4.0-Input-Policy
service-policy output AutoQos-4.0-Output-Policy
If Layer 3 interface:
Switch(config-if)# no service-policy input AutoQos-VoIP-Input-Dscp-Policy
no service-policy output AutoQos-VoIP-Output-Policy
service-policy input AutoQos-4.0-Input-Policy
service-policy output AutoQos-4.0-Output-Policy