Datasheet

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 6 of 8
Specification
Value
Notes
Operating temperature
–15 to 55°C
5 to 131°F
–25 to 60°C
–13 to 140°F
Dimensions: W x H x D
230 x 188 x 119 mm
9.1 x 7.4 x 4.7 in.
297 x 145 x 215 mm
11.7 x 5.7 x 8.5 in.
Weight
3.2 kg
7.0 lb
4.7 kg
10.4 lb
Housing: Ports are at the base of the housing for easy connection to underground cabling. (Left: A90100, right: A90300)
Notes:
1. Output level @ 1310 nm (m = 3.25%) or 1550 nm (m = 3%); valid for the node being configured with one RF output port.
2. Reducing output level will extend the AGC range as shown below.
Output Level
AGC Range dBm
@ 1310 nm (m = 3.25%) or 1550 nm (m = 3%)
Output Level
AGC Range dBm
@ 1310 nm (m = 3.25%) or 1550 nm (m = 3%)
117
–7 to 2
111
–10 to 2
116
–7.5 to 2
110
–10.5 to 2
115
–8 to 2
109
–11 to 2
Output Level
AGC Range dBm
@ 1310 nm (m = 3.25%) or 1550 nm (m = 3%)
Output Level
AGC Range dBm
@ 1310 nm (m = 3.25%) or 1550 nm (m = 3%)
114
–8.5 to 2
108
–11.5 to 2
113
–9 to 2
95 to 107
–12 to 2
112
–9.5 to 2
3. With internal plug-in splitter.
4. At 42 unmodulated ch. in CENELEC channel loading, EN50083-3, Output level 1x117 dBµV, 9 dB equalizer. Or at 41 unmodulated ch. in
CENELEC channel loading, EN50083-3 (without Band I), Output level 1x117 dBµV, 9 dB equalizer.
5. At 40 MHz decreasing with -1.5 dB/octave. With 0 dB link 74089. Forward output return loss≧18 dB at 40 MHz decreasing with -1.5 dB/octave
with diplex filter A75130.xxxx.
6. Depending on plug-in diplex filters.
7. Output ports to input reverse Tx depending on output splitter. Valid for the node being configured with one RF output port.
8. Below 40 MHz, above 40 MHz decreasing with 1.5 dB/octave with LP-link 77099. Reverse output return loss ≧18 dB at 40 MHz decreasing with
-1.5 dB/octave, the return path being equipped with optional reverse filter A73127.xxxx and diplex filter A75130.XXXX.
9. Depending on Reverse Tx specification.
10. Power consumption is 31W for network powered versions between 24 and 30V.
11. Only applicable for network powered versions.
12. The adapter type SC/APC to E2000 is available by the use of required accessory A90540.xxxxx.