Specifications

EFT Draft - CISCO CONFIDENTIAL
4-3
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)
OL-20861-01
Chapter 4 Setting Up the Cisco Unified IP Color Key Expansion Module
Installing a Key Expansion Module on the Cisco Unified IP Phone
Connecting a Single KEM to the Cisco Unified IP Phone
To connect a single KEM to the Cisco Unified IP Phone, follow these steps:
Procedure
Step 1 Position the phone so that the front of the phone is facing up.
Step 2 Connect one end of the KEM spine connector to the Accessory Connector on the Cisco Unified IP Phone.
Step 3 Connect the other end of the KEM spine connector to the KEM as shown in Figure 4-1.
Figure 4-1 Connecting the KEM Spine Connector to the Cisco Unified IP Phone and KEM
Step 4 Fasten the screws on the spine connector after connecting both the ends.
Note You can use a coin or screwdriver to fasten the screws. Make sure that the sides of the screw
heads are fully inserted into the spine connector cavity and tightened.
206800