Technical data

Known limitations and considerations in this release 35
Release Notes for the Passport 8600 Release 3.7.6
• Before removing a card, ensure that all ports from that card have been
removed from the NAAP VLAN.
Adding non-Firewall iSD ports to the NAAP VLAN makes those ports
Inter-Chassis-Link (ICL) members. Removing the card without removing
ports from the NAAP VLAN leaves invalid port entries in the ICL list.
(Q01028606)
• The VRRP sleeps if the system is left running for a long time without traffic.
In the case scenario, the system ran for over two days without traffic (one
cluster with two Firewall iSDs in HA mode and sync enabled). In this case,
when the VRRP status (using the
/i/n/v/s command) is checked, the
message “Error: operation failed” is returned. Continue to input the command
to verify status, and the system eventually returns to normal status.
(Q01007597)
• Deleted host from BBI causes a port configuration error (shown below) on the
remaining Firewall iSD. The error raised does not affect functionality because
the Firewall iSD must be reconfigured after it is removed from the cluster.
(Q00994834)
CRITICAL:Failed to apply port configuration [no such node /
Network/Hosts/1/Networks/2]
• VRRP must be configured after joining a new iSD. If the VRRP is not
configured, then the interface IP configuration does not work properly.
(Q00994895)
• After removing a Firewall iSD from a cluster, reboot the Firewall iSD to
prevent port configuration errors like those shown below. (Q01063352)
CRITICAL: Failed to apply port configuration [no such node
/Network/Hosts/1/Networks/2]
• Currently, the CLI command /c/n/port accepts any speed setting without
verification. Valid setting to be entered are: 10, 100, or 1000. (Q00995517)