Technical data

Supported standards, RFCs, and MIBs 17
Release Notes for the Passport 8600 Release 3.7.6
If the I/O modules you have are not of the required hardware revision level and
you want to use the new SMLT-on-single-CP functionality, you can order an
upgrade for your existing hardware using the part number A0537499.
(Q00854986, Q00815081-01) You can enable or disable the SMLT-on-single-CP
functionality by using the following CLI command:
config sys set smlt-on-single-cp <enable|disable>
[timer <value>]
Supported standards, RFCs, and MIBs
This section identifies the 802 standards, Request for Comments (RFCs), and
network management Management Information Bases (MIBs) supported in this
release. Documents listed here can be found online, at www.ietf.org/. Supported
standards are listed in Table 5.
Note: The Passport 8608SXE Routing Switch Module - 8 port
1000BASE-SX Gigabit Ethernet (part number DS1404036) is not
supported with this feature.
Table 5 Supported standards
Supported standards
802.3 CSMA/CD Ethernet ISO/IEC 8802-3
802.3i 10BaseT ISO/IEC 8802-3
802.3u 100BaseT ISO/IEC 8802-3
802.3z Gigabit Ethernet
802.3ab Gigabit Ethernet 1000BaseT 4 pair Cat5 UTP
802.3ae 10 Gigabit Ethernet
802.1Q and 802.1p VLAN tagging and prioritization
802.3ab Gigabit Ethernet Over Copper
802.3x Flow Control
802.1D MAC bridges/spanning tree protocol
802.3ad Link Aggregation Control Protocol
802.1x Extended Authentication Protocol