Specifications

Application Views Stratacom ATM Application
Device Management Page 85 Cisco Stratacom BPX8600 and IGX8400
CLP Low
The value of this field is equal to the Cell Loss
Priority (CLP) tagging deactivation threshold for
the other endpoint.
BCM
The value of this field enables the generation of
RM (Resource Management) cells when
congestion is detected in the connection. This is
the other endpoint view.
FGCRA
The value of this field enables Frame-based
Generic Rate Control Algorithm (FGCRA), which is
applicable with AAl-5 traffic only.
PCR
The Peak Cell Rate (0+1) (PCR), specifies an upper
bound on rate at which traffic can be submitted
on an ATM connection. This field applies to the
First Leaky Bucket for leaving cells with Cell Loss
Priority of “0” or “1.”
SCR
The Sustainable Cell Rate (SCR), is an upper
bound on the conforming average rate of an ATM
connection, over time scales which are long
relative to those for which the PCR is defined.
Enforcement of this bound by the UPC could
allow the network to allocate sufficient resources,
but less than those based on the PCR, and still
ensure that the performance objectives (e.g., Cell
Loss Ration) can be achieved.
MCR
Other end Minimum Cell Rate (MCR), specifies
the rate at which the source is always allowed to
send.
Endpoint Configuration
This option opens the Endpoint Configuration
view, which shows the ATM Endpoint Tables used
to model a PVC endpoint. These tables contain
the traffic parameters for ATM endpoint.
ATM Endpoint Table 1
Index
The index into the table for this endpoint.
Although only 5000 endpoints may exist on a
node, 10000 possible index values exist to
support DAX (intra-node) connections.
Description
Describes this endpoint. Contains information
about the domain, nodename, slot, port, VPI
(Virtual Path Identifier), and VCI (Virtual Channel
Identifier) for the endpoint. Domain and
nodename need not be given but slot, port, VPI,
and VCI values must exist.