Specifications

Application Views Stratacom Frame Relay Application
Device Management Page 76 Cisco Stratacom BPX8600 and IGX8400
Frame Relay Endpoint Enable FST parameter is
set to “true.”
% Utilization
The value of this object is equal to the channel
percentage utilization setting for this endpoint.
This is the expected long-term utilization of the
channel by this endpoint.
ForeSight
The value of this object determines whether or not
the ForeSight option is being used. If set to false,
the ForeSight is not used, and if true then
ForeSight will be used.
Priority
The value of this object determines the priority
that is given to the data. If set to low, then the
data is given the standard priority, and if set to
high, the data will be given a higher priority.
Higher priority data is placed at the beginning of
the port’s queues.
Group Flag
Specifies whether this is a grouped connection.
The MIB object Group Flag provides grouping
information about all the connections using that
Connection Table entry whereas this object
provides the same information for this endpoint.
Local Loopback
Specifies the Local Loopback state you can set for
the endpoint.
Loc Rmt Lpbk
Specifies the Local-Remote Loopback state you
can set for the endpoint.
Loopback State
Specifies the current Loopback state of the
endpoint. The value returned from this object is a
bitmap of the current loopback states which the
endpoint has configured. There are currently 16
loopback states an endpoint may have configured.
If NO LOOPBACK is configured, the agent will
return “-1.”
Test Type
Specifies the type of test the user would like to
conduct on this endpoint. There are currently two
types of tests. Test will exercise continuity, while
Test Delay will calculate the delay incurred on the
connection. The result of the Test Delay may then
be accessed through the Frame Relay Endpoint
Round Trip Delay object. To invoke a test, the
Admin Status is required to be set to test (4). The
NoLoop options provide the user the capability to
Note:
Note:
This object CANNOT be set for ATFR
or ATFST connection during
connection modification.