System information

Chapter 3. Ethernet switch interoperability 53
Figure 32. Switch Port Control / Status: Port 1
From the navigation window, we choose Control and Port. That brings us to
the Switch Port Control window shown in Figure 32. We select Port ID 1.
Then we set the Port Name to 42-01, 42 as the VLAN ID, and 01 as port
number 1. This is the first of two ports on VLAN 42.
The speed and duplex are set to AUTO-NEGOTIATE by the default and were
left unchanged in our test environment. See “Auto-speed negotiation” on
page 8.
Transmit pacing is set to DISABLE. When the pacing is on, the switch will
sense high network traffic and insert extra delays between frame
transmissions. There is no interoperability issues about transmit pacing, since
it only controls sending.
IEEE 802.1Q Connection type can be set either to Access or Hybrid.