System information

Chapter 3. Ethernet switch interoperability 45
Figure 24. Save configuration and reboot
From the System Configuration Menu we choose Save Configuration,
shown in Figure 24. This will force the switch to save the configuration to
NVRAM for a future reboot of the system. A Reboot System is not required
now since the changes have already been made to the running configuration.
Now we connect port 1.9 from the 8275-322 Switch, to port 0/7 on the Cisco
2924-XL, and port 1.10 to port 0/8. We connect one workstation to each
switch, and start pinging between the workstations. We have connection and
it seems to lose only one ping or none, when we disconnect one of the two
connections that forms the trunk. Everything works fine, and the configuration
was easy. From Figure 25 on page 46, we can see that the ports have
discovered speed and duplex mode from auto negotiating.