System information

Chapter 3. Ethernet switch interoperability 35
Figure 14. Trunking Port Management
We will need to reset the switch before the changes in configuration will take
effect (Figure 14). To perform a reset, we choose System Reset from the
System Utility menu in the navigation tree shown in Figure 15 on page 36.
Click the Apply button at the right, and the reset will take place. This is the
end of performing the configuration of the IBM 8275-322 switch. Now we have
all the ports in the same domain (or VLAN), and have port 1.9 and 1.10 set up
for trunking to be connected to the Cisco switch.