System information

© Copyright IBM Corp. 2000 125
Appendix B. Cisco 5500 configuration listing for the MPOA test
The configuration of the Cisco 5500 MPOA client is given here as a reference.
We will not discuss it in detail but only list the core configuration parameters
required to run a MPC LEC. Please refer to the Cisco documentation at
http://www.cisco.com for a more detailed description of the commands and
configuration parameters used in this example.
Cisco System Console Mon Feb 7 2000, 12:22:09
Catalyst5500 switch Configuration
cat5500-sup (enable) show config
#version 4.5(1)
set prompt cat5500-sup
#ip
set interface sc0 1 10.10.10.248 255.255.255.0 10.10.10.255
set interface sc0 up
set arp agingtime 1200
set ip route 0.0.0.0 10.10.10.242 1
!
#vtp
set vtp domain cisco
set vtp mode server
set vtp v2 disable
set vtp pruning disable
set vtp pruneeligible 2-1000
clear vtp pruneeligible 1001-1005
set vlan 1 name default type ethernet mtu 1500 said 100001 state active
set vlan 11 name VLAN0011 type ethernet mtu 1500 said 100011 state activ
set spantree enable all
#vlan1
set spantree fwddelay 15 1
set spantree hello 2 1
set spantree maxage 20 1
set spantree priority 8192 1
#vlan11
set spantree fwddelay 15 11
set spantree hello 2 11
set spantree maxage 20 11
set spantree priority 32768 11
#set boot command
set boot config-register 0x102
set boot system flash bootflash:cat5000-sup3.4-5-1.bin
!
#module 1 : 0-port supervisor III
set module name 1
!