System information

120 IBM and Cisco LAN Switching: Interoperability and Migration Guide
Figure 98. 8265 Configuration Part 2 of 2
1 8265 Operational Code level.
2 LECS address.
Figure 99. IBM 8265 Configuration
1 These modules were used for this test.
Default Gateway : OK
-------------------------------------------------------------------------------
IP address: 10.10.10.1
ARP Server:
-------------------------------------------------------------------------------
ATM address: 39.99.99.99.99.99.99.00.00.99.99.33.01.08.00.5A.99.0D.54.00
Device configured for PNNI port capability.
Device configured for Lan Emulation Servers.
Dynamic RAM size is 32 MB. Migration: off. Diagnostics: enabled.
Device defined as primary.
Memory profile: Mixed (32_P_M)
Duplicate ATM addresses are allowed.
Accounting is disabled.
8265_C2> show module all
Slot Install Connect Operation General Information
-------------------------------------------------------------------------------
1n n n-
2n p n-
3 Y Y Y 8265 ATM 3 Ports LAN 155 Mbps Module
4n p n-
5Y n n-
6n p n-
7 Y Y Y 8265 A-MSS 3 (FC5403) Module 1
8n p n-
9 Y Y Y 8265 ATM Control Point and Switch Module:Active 1
10 Y n n < Extension >
11 n p n -
12 Y Y Y 8265 ATM 622 Mbps Module
13 Y n n -
14 Y Y Y 8265 ATM 4 ports 155 Mbps Module 1
15 Y Y Y 8265 ATM 4 ports 155 Mbps Module
16 Y Y Y 8265 ATM 4 ports 155 Mbps Module 1
17 Y Y Y 8265 ATM 4 ports 155 Mbps Module
18 n n n -
19 Y n Y Active Controller ModuleThis is screen.