Troubleshooting guide

If the ping test fails (a ping success rate of 0 percent), you see output similar to the output shown below.
Router#ping 192.168.1.1
Type escape sequence to abort.
Sending 5, 100−byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
Router#
Related Information
Cisco DSL Technology Support Information•
Cisco DSL Product Support Information•
Technical Support − Cisco Systems•
Contact the Cisco Technical Assistance Center
If you need additional assistance implementing RFC1483 routing, contact the Cisco Technical Assistance
Center (TAC).
Note: To use the Case Open tool to open a case online, you must be a registered user and you must be logged
in.
Call the TAC
If you do not have a service contract with Cisco and need assistance implementing RFC1483 routing, direct
your web browser to Cisco's Warranty Status Tool.
RFC1483 Routing
Implementations Page
Main Page
All contents are Copyright © 1992−−2003 Cisco Systems Inc. All rights reserved. Important Notices and Privacy Statement.
Cisco DSL Router Configuration and Troubleshooting
Guide
ADSL WIC
The Asymmetric Digital Subscriber Line (ADSL) WAN interface card (WIC) is a 1−port WIC for the
modular Access Routers such as the Cisco 1700, 2600, 3600, and 3700 Series Routers. The card provides
ADSL high−speed digital data transfer between a single customer premises equipment (CPE) subscriber and
the central office. The ADSL WAN interface card (WIC−1ADSL) is referred to as the Cisco ADSL WIC card
throughout this page.
Cisco DSL Router Configuration and Troubleshooting Guide