Installation guide

Set Up the Router to Access the Network

78-6853-03

Set Up the Router to Access the Network

The Cisco Router Web Setup (CRWS) software is already loaded on your Cisco 827 router. You can use

CRWS to configure the Cisco 827 router. If you purchased your router through an Internet service

provider (ISP), it is possible that your router has been configured for use at your site. If you know this

is not the case, or if you have purchased Cisco IOS software for the router since installing it, we

recommend that you use CRWS to configure the router.

Step 1 Log on to the PC connected to the router through the ETHERNET port.

Step 2 Open a web browser.

Step 3 Type in the following universal resource locator (URL):

http://10.10.10.1

Step 4 Click the Router Setup link in the Cisco Router Web Setup home page, and follow the instructions that

appear in the page that is displayed.

Step 5 If the CRWS home page does not appear when you enter the URL http://10.10.10.1, test the connection

between the PC and the router by doing the following:

a. Check that the OK LED on the router is on, and check the cable connection between the router and

the PC. Be sure that the TO HUB/TO PC button is in the TO PC position.

b. If the CRWS home page still does not appear, verify that your web browser’s work offline option is

disabled.

c. If the web page still does not appear, verify that your PC is automatically configured to receive an

IP address, by following the instructions in Cisco Router Web Setup User Guide, which is available

on the Cisco Documentation CD-ROM.