Specifications

Configuring the Wireless Device
Starting a Wireless Configuration Session
3
OL-21850-01
Tip If you want to create an IOS software alias for the Console to session into the wireless device, enter the
alias exec dot11radio service-module wlan-ap 0 session command at the EXEC prompt. After entering
this command, you automatically skip to the dot11 radio level in the IOS.
Closing the Session
To close the session between the wireless device and the router’s console, perform both of the following
steps.
Wireless Device
1. Control-Shift-6 x
Router
2. disconnect
3. Press Enter twice.
Step 5
ip address subnet mask
Example:
router(config-if)# ip address 
10.10.0.30 255.255.255.0
Specifies the interface IP address and subnet
mask.
Step 6
exit
Example:
router(config-if)# exit
router(config)#
Exits the mode.
Step 7
exit
Example:
router(config)# exit
router#
Exits the mode.
Step 8
service-module wlan-ap 0 session
Example:
router# service-module wlan-ap0 session
Trying 10.21.0.20, 2002 ... Open
ap>
Opens the connection between the wireless device
and the router’s console.
1. GE0 = Gigabit Ethernet 0
Command Purpose