Specifications

Ensurepass.com Easy Test! Easy Pass!
Download the complete collection of Exam's Real Q&As www.ensurepass.com
QUESTION 105
What is the result of entering the command port-channel load-balance src-dst-ip on an Ether
Channel link?
A. Packets are distributed across the ports in the channel based on the source and destination
MAC addresses.
B. Packets are distributed across the ports in the channel based on the source and destination IP
addresses.
C. Packets are balanced across the ports in the channel based first on the source MAC address,
then on the destination MAC address, then on the IP address.
D. Packets are distributed across the access ports in the channel based first on the source IP
address and then on the destination IP addresses.
Correct Answer: B
QUESTION 106
Which Cisco IOS command globally enables port-based authentication on a switch?
A. aaa port-auth enable
B. radius port-control enable
C. dot1x system-auth-control
D. switchport aaa-control enable
Correct Answer: C
QUESTION 107
Which two steps are necessary to configure inter-VLAN routing between multilayer switches?
(Choose two.)
A. Configure a dynamic routing protocol.
B. Configure SVI interfaces with IP addresses and subnet masks.
C. Configure access ports with network addresses.
D. Configure switch ports with the autostate exclude command.
E. Document the MAC addresses of the switch ports.
Correct Answer: AB
QUESTION 108
Which statement correctly describes enabling BPDU guard on an access port that is also enabled
for PortFast?
A. Upon startup, the port transmits 10 BPDUs. If the port receives a BPDU, PortFast and BPDU