Specifications

Ensurepass.com Easy Test! Easy Pass!
Download the complete collection of Exam's Real Q&As www.ensurepass.com
command in global configuration mode.
B. Enter the no switchport command to disable Layer 2 functionality at the interface level.
C. Each port participating in routing of Layer 3 packets must have an IP routing protocol
assigned on a per-interface level.
D. Routing is enabled by default on a multilayer switch, so the port can become a Layer 3
routing interface by assigning the appropriate IP address and subnet information.
Correct Answer: B
QUESTION 103
You have configured a Cisco Catalyst switch to perform Layer 3 routing via an SVI and you have
assigned that interface to VLAN 20. To check the status of the SVI, you issue the show interfaces
vlan 20 command at the CLI prompt. You see from the output display that the interface is in an
up/up state. What must be true in an SVI configuration to bring the VLAN and line protocol up?
A. The port must be physically connected to another Layer 3 device.
B. At least one port in VLAN 20 must be active.
C. The Layer 3 routing protocol must be operational and receiving routing updates from
neighboring peer devices.
D. Because this is a virtual interface, the operational status is always in an "up/up" state.
Correct Answer: B
QUESTION 104
Refer to the exhibit, which is from a Cisco Catalyst 3560 Series Switch. Which statement about the
Layer 3 routing functionality of the interface is true?
A. The interface is configured correctly for Layer 3 routing capabilities.
B. The interface needs an additional configuration entry to enable IP routing protocols.
C. Since the interface is connected to a host device, the spanning-tree portfast command must
be added to the interface.
D. An SVI interface is needed to enable IP routing for network 192.20.135.0.
Correct Answer: A