Installation Instructions

2-7
Cisco 806 Router and SOHO 71 Router Hardware Installation Guide
78-10432-04
Chapter 2 Installation
Installing Your Router
Connecting a Hub
Before connecting a hub to the router, see Table 2-2 for information on setting the
TO HUB/TO PC button. To connect a hub, follow the steps in Figure 2-1.
(Figure 2-1 shows a Cisco 806 router, but the process is the same for a SOHO 71
router.)
Figure 2-1 Connecting a Hub
ETHERNET
SPEED
1
5
2
6
3
7
4
8
LED
100BaseTX
SOLID
10BaseT BLINK
1X 2X
3X 4X
5X
6X 7X
MDI MDI-X
8X
ETHERNET
TO HUB
TO PC
+5 VDC
3 2
1
10BASET
Model Cisco 806
COMPUTERS (E0)
ETHERNET 10BASET
INTERNET (E1)
CONSOLE
4
1. Set TO HUB/TO PC button.
4. If applicable, check setting
of hub equivalent of router
TO HUB/TO PC.
3. Connect other
end of cable
to hub.
2. Connect yellow cable
to ETHERNET port 4
on Cisco 806 router.
Cisco 806 router
Cisco 1528 Micro Hub 10/100
51815
To verify your hub connection, ensure that the COMPUTERS 4 LED on the front
panel is on after you have connected all cables and turned the router on. If the
LED does not turn on, see
Table 3-2 in Chapter 3 for troubleshooting information.
Note Leave PCs attached to the hub turned off until you have completed router
installation.