User guide
Table Of Contents
- Quick Reference Guide
- Table of Contents
- Getting Started
- Connecting Your Phone
- An Overview of Your Phone
- Basic Call Handling
- Using a Shared Line
- Using a Handset, Headset, and Speakerphone
- Using Phone Settings
- Using Call Logs and Directories
- Accessing the Voicemail System
- Troubleshooting Your Phone
- Index
Connecting Your Phone
IMT will likely initially connect your new Cisco Unified IP Phone to the APU IP telephony network. If
your phone needs to be moved for any reason, refer to the figure and table below to connect your
phone.
1
DC adaptor port (DC48V) – Not used
5
Access port (10/100 PC) – Plug into
computer data port
2
AC-to-DC power supply – Not used
6
Handset port
3
AC power cord – Not used
7
Headset port
4
Network port (10/100 SW) – Plug into data jack
8
Footstand button
Connecting Your Phone
Your Cisco phone is powered by and runs off of a data connection. Your phone should be plugged
into a data jack (see 4 above), NOT a phone jack. Your computer can then run off of the data
connection through the phone by plugging your computer into the phone (see 5 above).
Adjusting the Footstand
To change the angle that your phone sits on your desk, adjust the footstand while pressing the
footstand button.
3