Administration Manual

3-2
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Chapter 3 Setting Up the Conference Station
Before You Begin
Cisco Unified Communications Manager Configuration
The conference station requires Cisco Unified Communications Manager to handle call processing.
Refer to Cisco Unified Communications Manager Administration Guide or t
o context-sensitive help in
the Cisco Unified Communications Manager application to ensure that Cisco Unified Communications
Man
ager is set up properly to manage the conference station and to properly route and process calls.
If you plan to use auto-registration, verify that it is enabled and properly configured in
Cisco Unified Communications Manager before connecting any conference
station to the network. For
information about enabling and configuring auto-registration, refer to Cisco Unified Communications
Man
ager Administration Guide. Also, see the “Adding Conference Stations to the Cisco Unified
Communications Manager Database” sectio
n on page 2-7.
You must use Cisco Unified Communications Manager to configure and assig
n telephony features to the
conference stations. See the “Telephony Features Available for the Confe
rence Station” section on
page 5-1 for details.
In Cisco Unified Communications Manager, you can add users to the database and associate them with
specif
ic conference stations. In this way, users gain access to web pages that allow them to configure
items such as call forwarding, speed dialing, and voice messaging system options. See the
“Adding Users to Cisco Unified Communications Manager” section on page 5-9 for details.
Safety
Review the following warnings before installing the conference station. To see translations of these
warnings, refer to the Regulatory Compliance and Safety Information for Cisco Unified IP
Conference Stations documen
t that accompanied this device.
Warning Read the installation instructions before you connect the system to its power source.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning To avoid electric shock, do not connect safety extra low voltage (SELV) circuits to teleconference
station network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV
circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Caution Only use the proper Cisco approved external power supply. Reference the installation manual provided
with the conference station.