Specifications

Setting Up Call Handling
How to Set Up Call Handling for Incoming and Outgoing Calls
84
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
Step 3
transfer-system {blind | full-blind |
full-consult | local-consult}
Example:
Router(config-cm-fallback)# transfer-system
full-consult
Defines the call-transfer method for all lines served by the
Cisco Unified SRST router.
• blind—Calls are transferred without consultation with
a single phone line using the Cisco proprietary method.
Note: The keyword blind is not recommended. Use
either the full-blind or full-consult keyword instead.
• full-blind—Calls are transferred without consultation
using H.450.2 standard methods.
• full-consult—Calls are transferred with consultation
using a second phone line if available. The calls fall
back to full-blind if the second line is unavailable.
• local-consult—Calls are transferred with local
consultation using a second phone line if available. The
calls fall back to blind for nonlocal consultation or
nonlocal transfer target.
Step 4
transfer-pattern transfer-pattern
Example:
Router(config-cm-fallback)# transfer-pattern
52540..
Allows transfer of telephone calls by Cisco Unified IP
Phones to specified phone number patterns.
• transfer-pattern—String of digits for permitted call
transfers. Wildcards are allowed.
Step 5
exit
Example:
Router(config-cm-fallback)# exit
Exits call-manager-fallback configuration mode.
Timesaver Before exiting call-manager-fallback
configuration mode, configure any other
parameters that you need to set for the entire
Cisco Unified SRST phone network.
Step 6
voice service voip
Example:
Router(config)# voice service voip
(Optional) Enters voice service configuration mode.
Step 7
h323
Example:
Router(conf-voi-serv)# h323
(Optional) Enters H.323 voice service configuration mode.
Command or Action Purpose