Specifications

Setting Up Cisco Unified IP Phones
Where to Go Next
61
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
Verifying Cisco IP Communicator
Step 1 Use the show running-config command to display ephone-dn and ephone information associated with
this phone.
Step 2 After Cisco IP Communicator registers with Cisco Unified CME, it displays the phone extensions and
soft keys in its configuration. Verify that these are correct.
Step 3 Make a local call from the phone and ask someone to call you. Verify that you have a two-way voice path.
Troubleshooting Cisco IP Communicator
Step 1 Use the debug ephone detail command to diagnose problems with calls. For more information, see the
Cisco IOS Debug Command Reference. Go to
http://www.cisco.com/en/US/products/sw/iosswrel/tsd_products_support_category_home.html
and
click the appropriate Cisco IOS Software Release and Command References.
Where to Go Next
The next step is setting up call handling. For instructions, see the “Setting Up Call Handling” chapter.