Specifications

Overview of Cisco Unified SRST
Where to Go Next
35
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
Where to Go Next
The next chapters of this guide describe how to configure Cisco Unified SRST. As shown in Table 5,
each chapter takes you through these tasks in the order in which they need to be performed. The first task
for configuring Cisco Unified SRST is to ensure that the basic software and hardware in your system is
configured correctly for Cisco Unified SRST. For instructions, see the “Prerequisites for Configuring
Cisco Unified SRST” section on page 31.
Additional References
The following sections provide additional references related to Cisco Unified SRST:
• Related Documents, page 35
• Standards, page 37
• MIBs, page 37
• RFCs, page 37
• Technical Assistance, page 37
Related Documents
Table 5 Cisco Unified SRST Configuration Sequence
Task Where Task Is Described
1. Setting up a Cisco Unified SRST system
to communicate with your network
“Setting Up the Network” chapter
2. Setting up the basic Cisco Unified SRST
phone configuration
“Setting Up Cisco Unified IP Phones” chapter
3. Configuring incoming and outgoing calls “Setting Up Call Handling” chapter
4. Configuring optional system and phone
parameters
“Configuring Additional Call Features” chapter
5. Configuring optional security for SRST “Setting Up Secure Survivable Remote Site
Telephony” chapter
6. Setting up voice mail “Integrating Voice Mail with Cisco Unified SRST”
chapter
Related Topic Documents
SRST Commands
• Cisco Unified SRST and Cisco Unified SIP SRST Command
Reference (All Versions)
Cisco Unified IP Phones
• Cisco 7900 Series IP Phones End-User Guides
Command reference and configuration information for
voice and telephony commands
• Cisco IOS Voice Command Reference
• Cisco IOS Debug Command Reference Go to
http://www.cisco.com/en/US/products/sw/iosswrel/tsd_product
s_support_category_home.html and click the appropriate
Cisco IOS Software Release and Command References.