Specifications

Setting Video Parameters
How to Set Video Parameters for Cisco Unified SRST
177
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
Setting Video Parameters for Cisco Unified SRST
Using the following procedure to set the maximum bit rate for all video-capable phones in a
Cisco Unified SRST system.
SUMMARY STEPS
1. enable
2. configure terminal
3. call-manager-fallback
4. video
5. maximum bit-rate value
DETAILED STEPS
Examples
The following example shows the configuration for video with Cisco Unified SRST:
call-manager-fallback
video
maximum bit-rate 384
max-conferences 2 gain -6
transfer-system full-consult
ip source-address 10.0.1.1 port 2000
max-ephones 52
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Enters call-manager-fallback configuration mode.
Step 4
video
Example:
Router(config-call-manager-fallback)# video
Enters call-manager-fallback video configuration mode.
Step 5
maximum bit-rate value
Example:
Router(conf-cm-fallback-video)# maximum
bit-rate 256
Sets the maximum IP phone video bandwidth, in kbps. The
range is 0 to 10000000. The default is 10000000.