Specifications

Setting Video Parameters
How to Set Video Parameters for Cisco Unified SRST
169
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
Router# show voip rtp connections
VoIP RTP active connections :
No. CallId dstCallId LocalRTP RmtRTP LocalIP RemoteIP
1 102 103 18714 18158 10.1.1.1 192.168.1.1
2 105 104 17252 19088 10.1.1.1 192.168.1.1
Found 2 active RTP connections
============================
How to Set Video Parameters for Cisco Unified SRST
When the Cisco Unified SRST is enabled, Cisco Unified IP phones do not have to be reconfigured for
video capabilities because all ephones retain the same configuration used with Cisco Unified
CallManager. However, you can set video parameters for Cisco Unified SRST.
Setting Video parameters for Cisco Unified SRST involves the following tasks:
• Configuring Slow Connect Procedures, page 169
• Verifying Cisco Unified SRST, page 170
• Setting Video Parameters for Cisco Unified SRST, page 177
Configuring Slow Connect Procedures
Video streams require slow-connect procedures for Cisco Unified SRST. H.323 endpoints require a slow
connect because the endpoint-capability match occurs after the connect message.
Note For more information about slow-connect procedures, see Configuring Quality of Service for Voice.
Use the following procedure to configure slow-connect procedures.
SUMMARY STEPS
1. enable
2. configure terminal
3. voice service voip
4. h323
5. call start slow