Specifications

Integrating Voice Mail with Cisco Unified SRST
Where to Go Next
163
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
call-forward busy 1101
call-forward noan 1101 timeout 3
moh minuet.au
vm-integration
pattern direct * CGN
pattern ext-to-ext no-answer # FDN #2
pattern ext-to-ext busy # FDN #2
pattern trunk-to-ext no-answer # FDN #2
pattern trunk-to-ext busy # FDN #2
Configuring Voice-Mail Access over BRI and PRI: Example
The following example shows how to configure the Cisco Unified SRST router to forward unanswered
calls to voice mail. In this example, the voice-mail number is 1101, the voice-mail system is connected
to a BRI or PRI voice port, and the voice mailbox numbers are 3001, 3002, and 3006.
controller T1 2/0
framing esf
clock source line primary
linecode b8zs
cablelength short 133
pri-group timeslots 21-24
interface Serial2/0:23
no ip address
no logging event link-status
isdn switch-type primary-net5
isdn incoming-voice voice
isdn T309-enable
no cdp enable
voice-port 2/0:23
dial-peer voice 1102 pots
destination-pattern 1101T
direct-inward-dial
port 2/0:23
call-manager-fallback
timeouts interdigit 5
ip source-address 1.6.0.199 port 2000
max-ephones 24
max-dn 24
transfer-pattern 3...
voicemail 1101
call-forward busy 1101
call-forward noan 1101 timeout 3
moh minuet.au
Where to Go Next
For information about monitoring and maintaining Cisco Unified SRST, go to the “Monitoring and
Maintaining Cisco Unified SRST” chapter.