Specifications

Integrating Voice Mail with Cisco Unified SRST
How to Integrate Voice Mail with Cisco Unified SRST
149
Cisco Unified Survivable Remote Site Telephony Version 4.0 System Administrator Guide
How to Integrate Voice Mail with Cisco Unified SRST
This section contains the following tasks:
• Configuring Direct Access to Voice Mail, page 149 (Required)
• Configuring Message Buttons, page 152 (Required)
• Redirecting to Cisco Unified CallManager Gateway, page 154 (Required for BRI or PRI))
• Configuring Call Forwarding to Voice Mail, page 154 (Required FXO or FXS)
• Configuring Message Waiting Indication, page 159 (Optional)
Configuring Direct Access to Voice Mail
To access voice-mail messages with FXO or FXS access, you must have POTS dial peers configured with
a destination pattern that matches the voice-mail system’s number. Also, you must associate the dial peer
with the port to which the voice-mail system is accessed.
Both sets of configurations are done in global configuration mode and in dial-peer configuration mode.
The summary and detailed steps below include only the basic commands necessary to perform this task.
You may require additional commands for your particular dial-peer configuration.
SUMMARY STEPS
1. dial-peer voice tag {pots | voatm | vofr | voip}
2. destination-pattern [+] string [T]
3. port {slot-number/subunit-number/port | slot/port:ds0-group-no}
4. forward-digits {num-digit | all | extra}
5. exit