Specifications

Cisco Unified Wireless IP Phone 7921G Series Deployment Guide 48
Display On Time
displayOnTime
(([0-1][0-9])|(2[0-3])):[0-5][0-9]
Example: 07:30
Display On Duration
displayOnDuration
(([0-1][0-9])|(2[0-3])):[0-5][0-9]
Example: 10:30
Display Idle Timeout
displayIdleTimeout
(([0-1][0-9])|(2[0-3])):[0-5][0-9]
Example: 01:00
Phone Book Web Access
phoneBookWebAccess
0 = Deny All; 1 = Allow Admin
Unlock-Settings Sequence
unlockSettingsSequence
0 = Disabled; 1 = Enabled
Application Button
Activation Timer
appButtonTimer
0 = Disabled; <1-5> = <1-5> seconds
Application Button
Priority
appButtonPriority
0 = Low; 1 = Medium; 2 = High
Out of Range Alert
outOfRangeAlert
0 = Disabled; 1 = Beep Once; <2-4> = Beep
every <10,30,60> seconds
Scan Mode
scanningMode
0 = Auto; 1 = Single AP; 2 = Continuous
Restricted Data Rates
restrictDataRates
0 = Disabled; 1 = Enabled
Power Off When Charging
powerOffWhenCharging
0 = Disabled; 1 = Enabled
Cisco Discover Protocol
(CDP)
cdpEnable
0 = Disabled; 1 = Enabled
Advertise G.722 Codec
g722CodecSupport
0 = Use System Default; 1 = Disabled; 2 =
Enabled
Home Screen
homeScreen
0 = Main Phone Screen; 1 = Line View
FIPS Mode
fipsMode
0 = Disabled; 1 = Enabled
Auto Line Select
autoSelectLineEnable
0 = Disabled; 1 = Enabled
Minimum Ring Volume
minimumRingVolume
0 = Silent; <1-7> = Different Volume Levels
Application Button
thumbButton1
PTTH<1-6>
With Cisco Unified Communications Manager Express, the “thumbButton1” command can tie the application button to a
specific line.
For example, if line 2 is an intercom line tied to a multicast paging group, then this can be configured to achieve Push To Talk.
Enable individual phone configuration files with the following commands.
telephony-service