Specifications

Cisco Unified Wireless IP Phone 7921G Series Deployment Guide 30
Designing the Wireless LAN for Voice
The following network design guidelines must be followed in order to accommodate for adequate coverage, call capacity and
seamless roaming for the Cisco Unified Wireless IP Phone 7921G.
For more information about these topics, refer to the “VoWLAN Design Recommendations” chapter in the Enterprise Mobility
Design Guide at this URL:
http://www.cisco.com/en/US/docs/solutions/Enterprise/Mobility/emob41dg/eMob4.1.pdf
Planning Channel Usage
Use the following guidelines to plan channel usage for these wireless environments.
5 GHz (802.11a)
The Cisco Unified Wireless IP Phone 7921G supports Dynamic Frequency Selection (DFS) and Transmit Power Control (TPC)
from 802.11h, which are required when using channels operating at 5.25 - 5.725 GHz, which are 15 of the 23 possible channels.
DFS dynamically instructs a transmitter to switch to another channel whenever radar signal is detected. If the access point
detects radar, the radio on the access point goes on hold for at least 60 seconds while the access point passively scans for
another usable channel.
TPC allows the client and access point to exchange information, so that the client can dynamically adjust the transmit power.
The client uses only enough energy to maintain association to the access point at a given data rate. As a result, the client
contributes less to adjacent cell interference, which allows for more densely deployed, high-performance wireless LANs.
Lower power on the client provides longer battery life because less power is used by the radio.
5 GHz channels overlap their adjacent channel, so there should be at least 1 channel of separation for adjacent access points.