Installation guide

Chapter 1 An Overview of the Cisco Unified Wireless IP Phone 7921G
Overview of Configuring and Installing the Cisco Unified Wireless IP Phone 7921G
1-22
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified CallManager Release 4.1, 4.2, 5.0
OL-10802-01
Installing the Cisco Unified Wireless IP Phone 7921G
After you have added the phones to the Cisco Unified CallManager database, you
can complete the phone installation. You (or the phone users) can install the phone
at the users’s location. The Cisco Unified Wireless IP Phone Installation Guide
that ships in the box with each phone provides directions for assembling the phone
and accessories and charging the battery.
Prior to using the phone to connect to the wireless LAN, you need to configure a
network profile for the phone. You can use the Cisco Unified Wireless IP Phone
7921G web pages to set up the network profile and other phone settings, or you
can configure the network profile using phone menus.
If you use auto-registration with Cisco Unified CallManager, you need to update
the specific configuration information for the phone such as associating the phone
with a user, changing the softkey template, or directory number.
Note Before you install a phone, even if it is new, upgrade the phone to the current
firmware image. For information about upgrading, refer to the Readme file for
your phone which is located at:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900ser-crypto
Related Topic
Checklist for Installing the Cisco Unified Wireless IP Phone 7921G, page 1-22
Checklist for Installing the Cisco Unified Wireless IP Phone 7921G
Table 1-4 provides an overview and checklist of installation tasks for the
Cisco Unified Wireless IP Phone 7921G. The list presents a suggested order to
guide you through the phone installation. Some tasks are optional, depending on
your system and user needs. For detailed procedures and information, refer to the
sources in the list.