Specifications

4-19
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 8.0
OL-21033-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
SIP Configuration Menu for SIP Phones
The SIP Configuration menu is available on SIP phones. This menu contains the following sub-menus:
• SIP General Configuration Menu, page 4-19
• Line Settings Menu for SIP Phones, page 4-20
SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable SIP parameters on the
phone. Table 4-8 describes the options in this menu.
Table 4-8 SIP General Configuration Menu Options
Option Description To Change
Preferred CODEC Displays the CODEC to use when a call is initiated. Display only—cannot configure.
Out of Band DTMF Displays the configuration of the out-of-band signaling (for tone
detection on the IP side of a gateway). The Cisco Unified IP
Phone (SIP) supports out-of-band signaling by using the AVT
tone method. Valid values are none, avt, and avt_always.
Display only—cannot configure.
Register with Proxy This value is set to Yes. Display only—cannot configure.
Register Expires Displays the amount of time, in seconds, after which a
registration request expires.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Phone Label Displays the text that is displayed on the top right status line of
the display on the phone. This text is for end-user display only
and has no effect on caller identification or messaging.
Display only—cannot configure.
Enable VAD The default value is set to No. From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
VOIP Control Port Displays the UDP ports used for SIP messages. From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Start Media Port Displays the start Real-Time Transport Protocol (RTP) range for
media.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
End Media Port Displays the end Real-Time Transport Protocol (RTP) range for
media.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
NAT Enabled Displays if Network Address Translation (NAT) is enabled. Display only—cannot configure.