Specifications

4-8
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 8.0
OL-21033-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
Table 4-3 describes the IPv4 configuration menu options.
SW Port
Configuration
Speed and duplex of the network port (labeled 10/100 SW on the Cisco
Unified IP Phone 7970, and 10/100/1000 SW on the Cisco
Unified IP Phone 7971G-GE). Valid values:
• Auto Negotiate
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure the port on the switch to
the same speed/duplex as the phone, or configure both to auto-negotiate.
If you change the setting of this option, you must change the PC Port
Configuration option to the same setting.
1. Unlock network
configuration options.
2. Scroll to the SW Port
Configuration option
and then press the Edit
softkey.
3. Scroll to the setting that
you want and then press
the Select softkey.
4. Press the Save softkey.
PC Port
Configuration
Speed and duplex of the access port (labeled 10/100 PC on the Cisco
Unified IP Phone 7970, and 10/100/1000 PC on the Cisco
Unified IP Phone 7971G-GE). Valid values:
• Auto Negotiate
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure the port on the switch to
the same speed/duplex as the phone, or configure both to auto-negotiate.
If you change the setting of this option, you must change the SW Port
Configuration option to the same setting.
1. Unlock network
configuration options.
2. Scroll to the PC Port
Configuration option
and then press the Edit
softkey.
3. Scroll to the setting that
you want and then press
the Select softkey.
4. Press the Save softkey.
PC VLAN Allows the phone to interoperate with 3rd party switches that do not
support a voice VLAN. The Admin VLAN ID option must be set before
you can change this option.
1. Unlock network
configuration options.
2. Make sure the Admin
VLAN ID option is set.
3. Scroll to the PC VLAN
option, press the Edit
softkey, and then enter a
new PC VLAN setting.
4. Press the Valid a te
softkey and then press
the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change