Specifications

3-11
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 8.0
OL-21033-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Verifying the Phone Startup Process
Caution Use care not to damage wires or pipes located inside the wall when securing screws to wall studs.
Procedure
Step 1 Remove the footstand if it is attached to the phone.
Step 2 Insert two screws into a wall stud, matching them to the two screw holes on the back of the phone.
Step 3 Hang the phone on the wall.
Verifying the Phone Startup Process
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by
cycling through these steps.
1. These buttons blink or flash on and off:
– Handset light strip
– Hold button
– Applications Menu button
2. The screen displays the Cisco Systems, Inc., logo screen.
3. These messages display as the phone starts:
– Configuring IP
– Updating Trust List
– Verifying Load
– Configuring CM List
– Registering
4. The main screen displays:
– Current date and time
– Directory number
– Softkeys
If the phone successfully passes through these stages, it has started up properly. If the phone does not
start up properly, see Resolving Startup Problems, page 9-1.
Configuring Startup Network Settings
If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
• IP address
• IP subnet information
• Default gateway IP address