Specifications

ManualsBrandsCisco ManualsConsumer electronics7902G - Unified IP Phone VoIP

Configuring the SIP Registrar

How to Configure the SIP Registrar

Cisco Unified SIP SRST 4.0 System Administrator Guide

Step 6 show dial-peer voice

Finally, use the show dial-peer voice command on dial peer 40036, and notice the monitor probe status.

Note Also highlighted is the output of the cor and incoming called-number commands.

Router# show dial-peer voice

VoiceOverIpPeer40036

peer type = voice, information type = voice,

description = `',

tag = 40036, destination-pattern = `91011',

answer-address = `', preference=1,

CLID Restriction = None

CLID Network Number = `'

CLID Second Number sent

source carrier-id = `', target carrier-id = `',

source trunk-group-label = `', target trunk-group-label = `',

numbering Type = `unknown'

group = 40036, Admin state is up, Operation state is up,

incoming called-number = `', connections/maximum = 0/unlimited,

! Default output for incoming called-number command

DTMF Relay = disabled,

modem transport = system,

huntstop = disabled,

in bound application associated: 'DEFAULT'

out bound application associated: ''

dnis-map =

permission :both

incoming COR list:maximum capability

! Default output for cor command

outgoing COR list:minimum requirement

! Default output for cor command

Translation profile (Incoming):

Translation profile (Outgoing):

incoming call blocking:

translation-profile = `'

disconnect-cause = `no-service'

advertise 0x40 capacity_update_timer 25 addrFamily 4 oldAddrFamily 4

type = voip, session-target = `ipv4:10.2.161.187',

technology prefix:

settle-call = disabled

ip media DSCP = ef, ip signaling DSCP = af31,

ip video rsvp-none DSCP = af41,ip video rsvp-pass DSCP = af41

ip video rsvp-fail DSCP = af41,

UDP checksum = disabled,

session-protocol = sipv2, session-transport = system,

req-qos = best-effort, acc-qos = best-effort,

req-qos video = best-effort, acc-qos video = best-effort,

req-qos audio def bandwidth = 64, req-qos audio max bandwidth = 0,

req-qos video def bandwidth = 384, req-qos video max bandwidth = 0,

RTP dynamic payload type values: NTE = 101

Cisco: NSE=100, fax=96, fax-ack=97, dtmf=121, fax-relay=122

CAS=123, ClearChan=125, PCM switch over u-law=0,A-law=8

RTP comfort noise payload type = 19

fax rate = voice, payload size = 20 bytes

fax protocol = system

fax-relay ecm enable

fax NSF = 0xAD0051 (default)

codec = g729r8, payload size = 20 bytes,

Media Setting = flow-through (global)