Specifications

CHAPTER

1-1

Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E

78-14064-04

Product Overview

The Cisco IOS on the Cisco 7600 Series Router product supports the following hardware and software:

• Supervisor Engine 2, Policy Feature Card 2 (PFC2), and Multilayer Switch Feature Card 2

(MSFC2); and in Catalyst 6500 series switches:

–

Switch Fabric Module

–

Fabric-enabled switching modules

–

Fabric-enabled switching modules with a distributed forwarding card (DFC)

• Supervisor Engine 1, PFC, and MSFC or MSFC2

• All Layer 2 and Layer 3 configuration from the same user interface

• Except for VLANs, Layer 2 and Layer 3 configuration is stored in a standard IOS configuration file

Refer to the Release Notes for Cisco IOS on Catalyst 6500 Series Switches and Cisco 7600 Series Router

publication for complete information about the chassis, modules, and software features supported by the

Cisco 7600 series routers:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/ol_2310.htm

The Cisco IOS on the Cisco 7600 Series Router product supports configuration using:

• CLI—See Chapter 2, “Command-Line Interfaces”

• SNMP—Refer to the IOS Configuration Fundamentals Configuration Guide and Command

Reference at this URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/index.htm

• IOS web browser interface—Refer to “Using the Cisco Web Browser” in the IOS Configuration

Fundamentals Configuration Guide and Command Reference at this URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/index.htm

• Embedded CiscoView—See the “Configuring Embedded CiscoView Support” section on page 1-1.

Configuring Embedded CiscoView Support

These sections describe the Embedded CiscoView support available with Release 12.1(20)E and later

releases:

• Understanding Embedded CiscoView, page 1-2

• Installing and Configuring Embedded CiscoView, page 1-2

• Displaying Embedded CiscoView Information, page 1-3