Installation guide

Cisco Clock Module (WS-C6K-CL and WS-C6513-CL) and VTT Module (WS-C6K-VTT) Installation Note

78-10498-05

Related Documentation

Step 3 Remove the new clock from the antistatic bag.

Step 4 Hold the module with the connector away from you.

Step 5 Carefully press the module onto the connector.

Step 6 Replace the four securing screws.

Step 7 Repeat Step 1 through Step 6 to install any additional clock modules.

Step 8 Replace the front panel safety cover and power up the switch.

Warning

The safety cover is an integral part of the product. Do not operate the unit without the safety cover

installed. Operating the unit without the cover in place will invalidate the safety approvals and pose

a risk of fire and electrical hazards.

Step 9 Enter the show environment command to verify the status of the replaced module.

This example shows that the clock module is functioning properly:

Console> show environment

Environmental Status (. = Pass, F = Fail, U = Unknown, N = Not Present)

PS1:. PS2:N PS1 Fan:. PS2 Fan:N

Chassis-Ser-EEPROM:. Fan:.

Clock(A/B):A Clock A:. Clock B:.

VTT1:. VTT2:. VTT3:.

Console>