Installation guide

7
Cisco Clock Module (WS-C6K-CL and WS-C6513-CL) and VTT Module (WS-C6K-VTT) Installation Note
78-10498-05
Replacing the VTT Modules and Clock Modules
Note Note the position of the VTT module before you remove it from the switch chassis because you must
install the new VTT module in the same position.
To replace the VTT module, perform these steps:
Step 1 Remove the two screws that secure the VTT module.
Step 2 Gently lift and remove the VTT module, placing it on an antistatic mat or foam.
Step 3 Remove the new VTT from the antistatic bag.
Step 4 Hold the module with the connector away from you.
Step 5 Carefully press the module onto the connector.
Step 6 Replace the two securing screws.
Step 7 Repeat Step 1 through Step 6 to install any additional VTT modules.
Step 8 Replace the front panel safety cover and power up the switch.
Warning The safety cover is an integral part of the product. Do not operate the unit without the safety cover
installed. Operating the unit without the cover in place will invalidate the safety approvals and pose
a risk of fire and electrical hazards.
Step 9 Enter the show environment or show environment status command to verify the status of the replaced
module.
This example shows that the VTT module is functioning properly:
Console> show environment
Environmental Status (. = Pass, F = Fail, U = Unknown, N = Not Present)
PS1:. PS2:N PS1 Fan:. PS2 Fan:N
Chassis-Ser-EEPROM:. Fan:.
Clock(A/B):A Clock A:. Clock B:.
VTT1:. VTT2:. VTT3:.
Console>
Replacing the Clock Module
Caution Always use an ESD wrist strap when handling modules or coming into contact with internal components.
Note Note the position of the clock module before you remove it from the switch chassis because you must
install the new clock module in the same position.
To replace the clock module, perform these steps:
Step 1 Remove the four screws that secure the clock module.
Step 2 Gently lift and remove the module, placing it on an antistatic mat or foam.