User guide

7
Release Notes for Cisco 7200/7400 Series Manager Release 1.1 on Solaris
78-14030-01
Known and Resolved Problems
CSCdv87954 No linkUp trap displayed for
voice interfaces.
When DS1 interface is shut down, Link <link
number> down status is displayed in the event
browser. But when a “no shut” is done on the same
interface, Link <link number> up status is not
displayed. Currently no workaround is available.
CSCdt89681 No value is displayed in ATM
PVC Performance dialog.
Because Cisco 7200/7400 routers do not fully
support ATM MIBs, the Cisco 7200/7400 Series
Manager cannot support any field displayed in
PVC Performance dialog box. Currently no
workaround is available.
CSCdu57577 Commission on I/O cards leaves
interface in commissioning state
When the I/O cards are deployed manually, the
interfaces under the I/O cards are created. When
the card is commissioned, it moves to
commissioning state, but the interface for IO2FE,
IOGEE, and IO remains in the commissioning
state. For IOFE card interfaces, mismatched state
is displayed.
To work around problem, use autodiscovery.
CSCdu57683 Deployment of IO GE+E card
creates Ethernet interface 0/1
Subchassis discovery creates nonexisting
interface 0/1. Currently no workaround is
available.
CSCdv10222 CAR policy status is not
dynamically updated
CAR policy status is not getting updated
dynamically even though dynamic updates are
enabled.
To work around problem, apply car policy on an
interface. Click any other interface and then click
the interface on which the car policy was applied.
CSCdw19279 Manual deploy: interface state
goes to lostcomms state
During the manual deployment of voice cards,
when the card type is not set, commissioning the
card makes the interface to move to lostcomms
state. Currently no workaround is available.
Table 1 Cisco 7200/7400 Series Manager Known Problems (continued)
Bug ID Summary Explanation